OpenWAM » How to add throttle valve??

How to add throttle valve??

Home › Forums › Running & Solving › How to add throttle valve??

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 11, 2014 at 8:10 am #333
    Leonktz LeonktzLeonktz Leonktz
    Member

    Hi,
    I am modelling a single cylinder si engine. I don’t know how to use the throttle valve in it and its input parameters. please give me some suggestion..

    December 17, 2014 at 9:42 pm #497
    sreenathiit12sreenathiit12
    Member

    A throttle valve can be modelled by a simple discharger coefficient. Do you want to control it during the simulation or it will have a fixed value?

    December 19, 2014 at 5:48 am #498
    Leonktz LeonktzLeonktz Leonktz
    Member

    For a simulation it will have a fixed value. But i am trying to analyse the output characteristics of an engine by varying the throttle position for different simulation.

    December 23, 2014 at 4:04 pm #499
    sreenathiit12sreenathiit12
    Member

    Then a simple discharge coefficient could be enough. You can change the value for each simulation

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.

Comments are closed.