OpenWAM » How to add Twin flow turbine?

How to add Twin flow turbine?

Home › Forums › OpenWAM submodels › The Turbocharger › The turbine model › How to add Twin flow turbine?

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 7, 2010 at 12:55 pm #286
    Edwin ArroyoEdwin Arroyo
    Participant

    – Actually i want to study the effects of the twin-entry turbine, but when i tried to add it to 4 stroke, 4 cylinder engine example , i noticed that if i tie duct 17 to one stator and duct 18 to the second stator , i do not know where to put duct 19 in the example ? can you please guide me to add twin-entry turbine to the example model?

    – How to add new number to new ducts, should i have to start from the last number ,in the model example the last duct number is 71, so if i want to add new ducts or new stator i have to start from the last? how is it working?

    July 8, 2010 at 2:12 pm #409
    sreenathiit12sreenathiit12
    Member

    Pipe 19 in the example represents the EGR duct. Do you want to make a model with EGR? In this case connect it to other junction in the exhaust manifold.

    Do not worry about the numeration. WAMer is able to numerate the elements automatically. You have 2 options:

    • Right-click on the engine and click on “Numerate”.[/*:2v2jgcl6]
    • In case you do not have an engine click on “Edit” menu and select “Numerate”
  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed.