OpenWAM » how to decide the mesh size??

how to decide the mesh size??

Home › Forums › OpenWAM submodels › The ducts › Numerical methods › how to decide the mesh size??

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 19, 2014 at 4:26 pm #334
    Leonktz LeonktzLeonktz Leonktz
    Member

    Hi,
    what is the optimum range of mesh size for the ducts?
    are there any technical papers that I can refer?

    December 23, 2014 at 4:05 pm #500
    sreenathiit12sreenathiit12
    Member

    Try to put 5 nodes per duct minimum. Then the mesh size will depends on the length of the pipe.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed.