OpenWAM » Implementing variable valve timing

Implementing variable valve timing

Home › Forums › OpenWAM submodels › Engine control unit › Implementing variable valve timing

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 8, 2012 at 12:17 pm #317
    Anonymous
    Inactive

    How would one implement variable valve timing and lift using the control units?

    March 9, 2012 at 9:36 am #480
    sreenathiit12sreenathiit12
    Member

    Connect the output of a controller (PID, look up table, switch) by dragging and dropping. A red “C” will appear over the valve. Now, if you enter to the information of the valve you will see a new tab called control. There you can decide the parameter that you want to control (lift, valve opening angle and duration)

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed.