Hello
I am currently evaluating OpenWAM for gasdynamic calculations.
Attached you find a simple example I set up as a test case.
I want to run 0.1 seconds, but the run stops after 1% of this time.
The output reads as follows:
=======================
OpenWAM v2.1.0 Build 2
=======================
THE MODEL IS READING THE INPUT DATA
Number of pipes: 3
INFO: Pipe n. 1 – N. of cells 101 – Mesh size = 0.01 m.
INFO: Pipe n. 2 – N. of cells 101 – Mesh size = 0.01 m.
INFO: Pipe n. 3 – N. of cells 3 – Mesh size = 0.01 m.
Number of boundary condition: 5
INFO: The input file data has been readed correctly
INFO: File successfully deleted
Seconds since 1 / 1 / 1970 GMT : 1502697222
Thousandths of a second : 406
===================================
Progress : 1.00092%
———————————–
Time left to the end: 0:00:16,517
===================================
===================================
Time consumed: 0:00:00,230
===================================
INFO: *** CMT : SIMULATION FINISHED CORRECTLY ***
Are there any user mistakes by myself, or is there some other problem?
What can I do?
I would really like to use OpenWAM for my calculation due to its 1D approach.
Best Regards
Manuel
.