OpenWAM » transient at variable speed option

transient at variable speed option

Home › Forums › Running & Solving › transient at variable speed option

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 12, 2012 at 1:04 am #307
    Anonymous
    Inactive

    First I want to say thanks for OpenWAM, it is an impressive piece of work -THANKS
    My question is about running in the variable speed mode with the vehicle model, it only accelerates for the first 10 revolutions. The number of cycles is set to 100 in the EJEC options, and there are 3 cycles without thermal inertia. The engine accelerates during these 3 cycles because the RPM is higher than the initial RPM when I look at the data.

    I would really like to just run a power vs RPM similar to dynamometer results, this mode is mentioned in the OPenWAM manual, but that option does not appear in the engine operating condition menu.
    Thanks so Much
    Tod

    October 15, 2012 at 7:21 am #464
    sreenathiit12sreenathiit12
    Member

    You can modify the engine speed by means of a controller.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed.